About Vigo

 https://neaterheater.es/image/catalog/logo-vigo.jpgconvector heaters are intended for full central heating of the home and there is a
large variety of models. The heaters are simple to install and more user friendly than ever.

They are manufactured in Turkey and now sold all over Europe.

The heaters are approved and certified according to international CCa specifications EN 60335 and carry the CE mark, thus complying with European safety standards.

Electric convector heaters are the devices that use energy with 100% efficiency

Electric convector heaters are the devices that use energy with 100% efficiency. 
They are easy to install and can be installed in every place where heating is required.
They provide comfortable and safe heating in homes, work places, offices, shops and
prefabricated buildings by presenting different solutions for all your heating needs.

The heat outlet on the front panel is designed to direct heat towards the centre of the room.
This reduces the possibility of dust collection above the heater.

All https://neaterheater.es/image/catalog/logo-vigo.jpg heaters are fitted with on/off switch and electronic thermostat, maintaining
a very stable room temperature.

https://neaterheater.es/image/catalog/logo-vigo.jpg  heaters come with smart energy consumption, Electronic timer, Child security lock,
Environmental temperature indicator, Energy consumption indicator, Low surface temperature. 

https://neaterheater.es/image/catalog/logo-vigo.jpg  Heaters are double insulated (ip24 rated) allowing them to be installed in bathrooms.

Stunning black glass heater

Heater Calculations

Measure the area of the room to be heated in m2. 
Allow 100 watts per m2 for areas needing to be warm, e.g. Living rooms and Bathrooms.
Allow 75-100 watts per m2 for areas such as bedrooms which you may not require to have
the same level of heating.
(add extra to rooms with higher than normal ceilings, remember some rooms are colder than others particularly north facing rooms)

Vigo Basic Electric Panel Convector Heater Model Selection


Recommended Heater Power (watt)

Room Area (m2)

EPK 4550 E05



EPK 4570 E10



EPK 4570 E15



EPK 4590 E20



EPK 4590 E25




The heat requirement depends on factors such as the exterior temperature, room heat insulation, door open / close cycles. The values stated on the above table are for average conditions therefore when calculating the heater power these factors should be taken into consideration

The approx running cost are 23 cents ( including iva ) per kilowatt hour,
based on Iberdrola standard tariff. 
(rates vary, please check your individual tariff on your electricity bill in your area) 
This means that for every 1 kw used continuously for one hour it will cost you 23 cents.
The total cost for a 1kw heater running continuously for 24 hours would therefore be € 5.52.
(These figures are greatly reduced with the thermostat in operation) 

You can work out roughly how much your heating would be using our heaters the following way.
Work out the square meterage of the room/rooms you want to heat.
The chart will show you the size of radiator in Watts that would be needed to effectively heat that room.
Each 100 watts will cost you 2.3 cents including iva per hour on the standard tariff (Iberdrolla´s figures, the correct term is 23 cents /kilowatt hour, it means the same).

The cost is varied by the fact that Vigo heaters have thermostats built into them and therefore are not running continuously for one hour as they will be reaching the set temperature and turning off.
The thermostat will also regulate according to differing factors like the outdoor temperature and how many open doors or windows you have in the area where the heaters are fitted.

A heater with a greater wattage does not use more energy, and does not cost more to run.
The heater’s element will be working less frequently, which also gives a lower surface temperature.

Please click here for a video on the operation of the digital heater

Please click here for heater calibration video